LAUNCH X431

 This is a tutorial on how to connect LAUNCH CRP IMMO Key Programmer step by step. Also showing the location of DLC on most vehicle models. Read also: LAUNCH CRP IMMO Quick Start & Upgrade Guide Where is the DLC(Data Link Connector) Location? The DLC (Data Link Connector or Diagnostic Link Connector) is typically a 16-pin connector where diagnostic code readers interface with the vehicle’s onboard computer. It is usually located 12 inches from the center of the instrument panel, under or around the driver’s side for most vehicles. For some vehicles with special designs, the DLC location may vary. Refer to the following figure for location. A — Opel, Volkswagen, Audi B — Honda C — Volkswagen D — Opel, Volkswagen, Citroen E — Changan F — Hyundai, Daewoo, Kia, Honda, Toyota, Nissan, Mitsubishi, Renault, Opel, BMW, Mercedes-Benz, Mazda, Volkswagen, Audi, GM, Chrysler, Peugeot, Regal, Beijing Jeep, Citroen and other most popular models. If the DLC cannot be f...

 This is a guide on how to start & upgrade LAUNCH CRP IMMO OBD Immobilizer Key Programmer for the first time. How to start LAUNCH CRP IMMO ? If it is the first time you have used this CRP IMMO tool , you need to make some system settings. Press the [Power] button to power it on. The screen displays a welcome page. Tap "Start" to go to next step. Choose the desired system language, and tap "Next". Choose the desired time zone, and tap "Next" to enter the WLAN setup page. Slide the switch to ON, the system starts searching for all available wireless LANs. Choose the desired WLAN access point / network, If the network you chose is open, you can connect directly; If the selected network is encrypted, you have to enter the right security key (network password). Note: If you choose "Ignore" in WLAN setup, it will go into the date setting page. If the tool has been properly connected to the Internet, the system will automat...