LAUNCH X431

 This is a tutorial on how to clone 6T45 BOSCH ECU with LAUNCH-X431 ECU & TCU Programmer on bench. You can also use the X431 X-PROG3 & PC Adaptor to do the job instead. Procedure Open X431 ECU & TCU Programmer software, search "6T45". Make: Chevrolet Model: Cruze 2008–2019 Engine: 1800 140 ECU: 6T45 Select BENCH connection type. Connect device, BOSCH module and PC according to "Direct connection of diagram". Click "Connect" after successful connection. Read FLASH data. After reading the original car ECU, disconnect it and replace it. Click "Disconnect". Click "Connect" after connecting to the new ECU. Read FLASH data. Save the new data file. Write FLASH data >> Selected the original data file Writing FLASH data successfully. Click "Disconnect" to exit. Chevrolet Cruze 6T45 BOSCH ECU clone was done. www.x431shop.eu

 This is a guide on how to clone Kia BOSCH MEG17.9.12 ECU with LAUNCH-X431 ECU & TCU Programmer by bench. Launch X-PROG 3 + PC Adaptor can follow the same operation steps as below. Open X431 ECU & TCU Programmer Software, Search "MEG17.9.12", Make: Kia Model: Cee’ d2013–2016 Engine: 1600 ECU:MEG 17.9.12-TCU_ST10F275 Select connection type: BENCH Click "Direct connection of diagram", connect the device to BOSCH ECU. Click "Read ECU information". Click "Read complete data". Save the file. Disconnect the device. Replace the ECU that needs to be cloned. Click "Read ECU information". Read complete after successful connection. Then write the original car data back to the new ECU. Write complete data >> Load FLASH data file Data is successfully written. Disconnect the device. Cloning ECU is completed. www.x431shop.eu

 This is a tutorial on using LAUNCH-X431 ECU & TCU Programmer to do TCU clearing function for Mercedes-Benz VGS3. You can use the X-PROG3 + PC Adaptor to do this job as well. Procedure Open X431 ECU & TCU programmer software, Search VGS3 Make: Mercedes Model: A-Class 2018 Engine: 2000 M260 ECU: VGS3-FDCT Select "BENCH" connection type. Click "Direct connection of diagram". There are 2 ways to connect, one is to read in the car and the other is to remove and read. Click "Connect". Click "EEPROM Data". After reading, the data backup. You need to write a new data in it. (You can contact customer service for the new data.) Click "Write EEPROM data" to load the file. Writing EEPROM data… Reading data succeeded. Remember to disconnect when completed. After the emptying is finished, you need to do the programming code. www.x431shop.eu