How to Fix Benz AMG GT TPMS Failure with LAUNCH CRT5011 V2?
To fix a tire pressure sensor failure on a 2023 BENZ AMG GT, use the LAUNCH Creader TPMS 5011 V2. This tool provides a complete solution for diagnosing, programming, and relearning the TPMS system to extinguish warning lights.
System Selection
Navigate to the following path on CRT5011 V2 Scanner:
TPMS >> MERCEDES >> AMG GT >> 2019/01–2024/12(433MHz)[X290][A0009052102]
Operational Steps
Diagnosis & Identification
- Select [Active] to trigger the four tire pressure sensors.
- If a sensor (e.g., Front Left/FL) fails to activate, it is confirmed as damaged.
Sensor Programming
- Remove the failed sensor and verify the part number or print number matches the menu.
- Navigate to Programming and select Auto to program a new Launch LTR-05 RF Sensor.
- You may also choose Manual input or Copy by OBD to duplicate the original sensor ID.
Installation & Activation
- Install the programmed Launch sensor into the wheel and inflate the tire to standard pressure.
- Select [Active] to trigger the new sensor at the specific wheel position.
System Relearning
- Go to Learning and select OBD Relearn to sync the data.
- Upon successful learning, the tire pressure light on the instrument panel will turn off.
Post-Service Verification
- If the tire pressure values do not display normally, a road test is required.
- Drive at a speed of 30km/h or above for 15 minutes to finalize the process.
Comments
Post a Comment