How to set LAUNCH X431 Tool to display miles

 Question: When I use the LAUNCH X431 diagnostic device for diagnosis, I find that the scanner displays kilometers, but my vehicle displays miles. How can I change the kilometers displayed in the LAUNCH X431 diagnostic device to miles?


How to set LAUNCH X431 Tool to display miles
How to set LAUNCH X431 Tool to display miles

Note: 142227 miles = 228893 kilometers

Solution:

Open the X-431 APP and set it up in the personal center. You can see that there are two options in the "Units" column: "Metric" and "English". Select "English" to display miles.


How to set LAUNCH X431 Tool to display miles

www.x431shop.eu

Comments

Post a Comment

Popular posts from this blog

LAUNCH CR529 User Guide: Reset Firmware / Upgrade Software

Image
 This article will introduce how to reset firmware/ upgrade software of LAUNCH CR529 . LAUNCH CR529 almost does the same job as some fancy tools at service centers do, with the support of all 10 OBD2 service modes, for All OBDII Car After 1996, with Full OBD2 Functions. Note: The LAUNCH CR519 tool has most of the software pre-installed when it leaves the factory, and users can "plug and play" after receiving the device. No need to upgrade the tool unless a bug needs to be fixed. Upgrade tool compatible with Windows 7/8/10/XP Only . LAUNCH CR529 firmware reset/ software upgrade steps: 1. Connect the scan tool to your computer through the USB cable provided. If the "Register Code" or "Serial Number" information appears, click "Exit" or stay on the page. 2. Find the CR529 update program on the LAUNCH official website [ https://en.cnlaunch.com/download/ ] and download the update program ( DIY integration upgrade tool ). 3. Unzip t...
Read more

THINKCAR ThinkDiag unable to connect via Bluetooth?

Image
 My THINKCAR ThinkDiag device was unable to connect via Bluetooth and download software. The error message displayed was: "Polaczenie Bluetooth nie powiodlo sie, odtacz zlacze i sprobuj ponownie. PROBUJ PONOWNIE (Bluetooth connection failed. Please close the connector and try again. TRY AGAIN)." Solution: Fix Firmware: Navigate to "More" > "Firmware Fix" > " THINKDIAG Firmware Fix". Re-plug the Device: Unplug and then re-plug the THINKCAR OBD2 Scanner . Log in to your account again. Update the App: Ensure the ThinkDiag app is updated to the latest version. Outcome: The problem was resolved! I can now connect via Bluetooth and download the software normally. www.x431shop.eu
Read more

Solved! LAUNCH X431 PAD 7 Firmware Update Failed

Image
  Problem: The Launch X431 PAD 7 is failed to update firmware, I just follow all steps but nothing work. Ensure to update device firmware V1.5.5: Connect WIFI, ensure Internet is good. Update time will take 3 mins, ensure device with enough power at least remain more than 20 percent. Don't press POWER button while update. X431 PAD VII gives an error display: "Device no response, please retry" Please check the device whether connect success. Service busy, please retry later. What's the problem? Any ideas? Solution Please remember to connect PAD 7 with X-PROG 3 Key Programmer before upgrade. That's the reason why firmware update failed. Read also: How to update Launch X431 GIII X-PROG 3 software? Technical Support www.x431shop.eu
Read more