Launch CRP919E Coding Change: Open and Close Porsche Convertible Top

 I'm trying to code a Porsche vehicle using the Coding Changes feature of Launch CRP919E. Open and Close Convertible Top from Key Fob (done and works).

Front-end Electronics:
Coding value- Comfort functions convertible top comfort opening = Yes {Default: No}

Front-end Electronics:
Comfort functions convertible top comfort closing = Yes{Default: Yes}

Rear-End Electronics:
Coding value-Equipment-Equipment for convertible top control equipment available = Yes {Default: Yes}
(I did not need to change this)

Rear-End Electronics:
Coding value- Equipment-Equipment for automatic convertible-top latch = Yes {Default: Yes}
(I am not sure if this is the correct code but I did not need to change this)

Rear-End Electronics:
Soft top coding- 981_soft top codings- Comfort function soft top remote control available = Yes {Default: No}

Rear-End Electronics:
Soft top coding- 981_soft top codings- Comfort function Close power window after open soft top with remote control = Yes {Default: No}

Rear-End Electronics:
Soft top coding- 981_soft top codings- Comfort function Close power window after close soft top with remote control = Yes {Default: No}

Launch CRP919E Coding Change Guide

Launch CRP919E Coding Change Guide

Launch CRP919E Coding Change Guide

Launch CRP919E Coding Change Guide

Launch CRP919E Coding Change Guide

This coding allows you to open and close the convertible top from your key fob and if you have entry & drive, to close your convertible top with the door handle.
Note that the door handle can only be used to put the top up. I could not get it to work to put the top down.

This coding also sets the windows to close after opening the top with the key fob. I corresponded with some 718 owners in the UK and Australia (who have this feature without coding) who confirmed that when they open their top with the key fob the windows close at the end of the cycle.

I would like the windows to completely close after opening the top with either the switch in the car, the key fob or inching mode. However, if the code to close windows after opening top is set to no, the windows stay at 3/4th open.

One other item I noticed testing it today is that neither the key fob nor the door handle worked with the car on. Probably not an issue in real life. However, I had the car on while testing and it took me a little bit to figure out why it was not working.

Note: If your windows close stay at 3/4th open rather than closing after opening the top with your key fob, try cycling the top up and down with the switch in the car and then try your key fob again.

Make sure the window position is working correctly (ie. windows are closing completely and not staying 3/4th open) before coding for touch and release of opening the convertible top (Item 7).

Additional Note: If you also code your windows to work with your key fob (item 14), your key fob will open and close your windows and not open or close your convertible top.

www.x431shop.eu

Comments

Popular posts from this blog

THINKCAR ThinkDiag unable to connect via Bluetooth?

How To Update LAUNCH X431 GIII X-PROG 3 Software?

Solved! LAUNCH X431 PAD 7 Firmware Update Failed